I am trying to apply MOHID3D to a nearshore zone with somewhat complicated coastlines and islets, but it crashes over and over.
Here is the description of my simulation:
-I used the same modules as in the Tagus sample only without discharge module.
-My bathymetry was made by MOHID Studio using the option of constant spaced grid, (DX, DY = 0.005 dgree).
-Tide was generated as fes2004.nc
When I tried a time increment DT=10sec (Courant Number is 1.015), the model ran very well.
But when DT was bigger than 10sec (Courant Number exists between 3 and 4), the model execution after several time steps stopped showing a log message like
-9.8999995E+15 -9.8999995E+15 227 342 2
Then I turned off the keyword ADVECTION_DIFFUSION (other options are the same), and found that the model ran well (even with DT=30).
Can anybody tell me how to get a complete run even with (DT =30, ADVECTION_DIFFUSION : 1)?
Thanks in advance.
MOHID Water forum. Questions and discussion around MOHID Water
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests