## How to make mohid read faecal colifoms dataseries

MOHID Water forum. Questions and discussion around MOHID Water
robson.epagri@gmail.com
MOHID Beginner
Posts: 1
Joined: Thu Dec 04, 2014 21:19

### How to make mohid read faecal colifoms dataseries

I am modeling the dispersion and decay of faecal coliforms discharged by a river into a coastal embayment, through an Eulerian approach. I have measured discharge and faecal coliform results for this river, so I don't want Mohid to adopt default values in the calculations. I am trying to set it up to read the data series. I succeeded to set up Mohid to read the discharge data series, however I am not having progress in the case of the faecal coliforms.
First of all, does Mohid read coliform concentration data series, or only default values?
In the case of discharges, what I did was to indicate to Mohid the DISCHARGE_FILE and the FLOW_COLUMN in the Discharges Module. In the case of coliforms, in the property "fecal coliforms" I am trying to do a similar thing. I am using as reference the commands I found in Mohid wiki "Module_LagrangianGlobal" (below) but it is not working... Any ideas on how to solve this problem? Thanks!

Reference from Mohidwiki:
<<BeginProperty>>
NAME  : fecal coliforms
UNITS  : MPN/100ml
CONCENTRATION  : 0
CONC_VARIABLE  : 1
CONC_COLUMN  : 2
DISCHARGE_FILE  : *****.***
T90_VARIABLE  : 0
T90_VAR_METHOD  : 0
T90  : 10800
T90_FILE  : T902.dat
T90_COLUMN  : 2
OUTPUT_HDF  : 1
TIME_SERIE  : 0
<<EndProperty>>

What I am doing:
<<beginproperty>>
NAME : fecal coliforms
UNITS : MPN/100ml
CONCENTRATION : 0
CONC_VARIABLE : 1
CONC_COLUMN : 4
DISCHARGE_FILE : ..\General Data\Initial Conditions\coliforms.dat
<<endproperty>>