water quality

Mohid Studio general discussion forum
MOHID Beginner
Posts: 6
Joined: Wed Dec 04, 2013 05:34

water quality

Postby cesartorres.14@hotmail.com » Thu Oct 23, 2014 19:31

I am simulating dissolved oxygen
and in the calibration
I tried altering certain variables that are affected by the DO in water quality module
and I can not change the OD
I need the OD increases,
How do I can do it? in What module i can calibrate water quality? What parameter should be altered to raise the OD?

in advance thank you very much

MOHID Advanced user
Posts: 187
Joined: Thu Jan 01, 1970 00:00

Re: water quality

Postby davidbrito » Fri Jun 26, 2015 15:05


The DO should be calibrated in WaterQuality.dat file in the terms that affect it.

See the WaterQualityManual
http://maretec.mohid.com/PublicData/pro ... Manual.pdf
and you have oxygen cycle and the rates that affect oxygen.

Hope it helped.

Best regards,

This post should go to MOHID Water section

Return to “MOHID Studio”

Who is online

Users browsing this forum: No registered users and 1 guest