Greetings
I am simulating dissolved oxygen
and in the calibration
I tried altering certain variables that are affected by the DO in water quality module
and I can not change the OD
I need the OD increases,
How do I can do it? in What module i can calibrate water quality? What parameter should be altered to raise the OD?
in advance thank you very much
water quality
-
- MOHID Advanced user
- Posts: 187
- Joined: Thu Jan 01, 1970 00:00
Re: water quality
Hello,
The DO should be calibrated in WaterQuality.dat file in the terms that affect it.
See the WaterQualityManual
http://maretec.mohid.com/PublicData/pro ... Manual.pdf
and you have oxygen cycle and the rates that affect oxygen.
Hope it helped.
Best regards,
David
This post should go to MOHID Water section
The DO should be calibrated in WaterQuality.dat file in the terms that affect it.
See the WaterQualityManual
http://maretec.mohid.com/PublicData/pro ... Manual.pdf
and you have oxygen cycle and the rates that affect oxygen.
Hope it helped.
Best regards,
David
This post should go to MOHID Water section
Who is online
Users browsing this forum: No registered users and 1 guest