Problems in the visualization of sections - Post processor

[paulo.chambel@hidromod.com]

Question made by Nuno Vaz.

\"I'm able to see a cross section in post-processor along XZ if I assume the entire domain in the Y direction (lines = 1:80). However, if a choose to see only part of the Y direction (lines = 50:65) the picture disappears.\"

[paulo.chambel@hidromod.com]

Nuno,
this is a stupid thing of the post-processor. The tool do always the calculations based in the maximum depth of the entire Y direction. The conseuqence is that the picture is visible but is outside of the zoom done automaticly by the tool. You need to pan uppeard several times (order of 10).

Paulo